Code-blue CB 9-S SIGNATURE SHORT ENCLOSURE Bedienungsanleitung PDF herunterladen (Seite 28)

Code Blue

•

259 Hedcor Street

•

Holland, MI 49423 USA

•

800.205.7186

•

www.codeblue.com

GU-159-Dpage 28 of 38

CB 9 Series

Administrator Guide

1.0 ATTACH J-BOX TO THE POLE

1.1 Thread the banding (B) through the pole bracket (A) located on the backside of the J-box (C).

1.2 Wrap the banding around the pole. Cut the banding to desired length.

1.3 Using a screwdriver or nut driver, tighten the banding and make sure that the unit is in the desired

location.

NOTE: J-box must be positioned so weep hole faces down.

2.0 ATTACH LIGHT TO BRACKET

3.1 Using the three M4 X 8 screws enclosed (K), fasten the strobe (J) to the round portion of the

strobe bracket.

NOTE: If the beacon/strobe is mounted upside-down, a drain hole must be drilled into the lens

to prevent it from lling with water.

3.0 ATTACH LIGHT AND BRACKET TO THE J-BOX

4.1 Connect all wiring from the strobe to the wiring from the unit inside of the J-box using wire nuts.

4.2 Attach strobe bracket to the J-box using four 6-32 X ½ screws as shown.

All wiring must be installed and connected by experienced and certied personnel to meet local and national electrical codes, and will

include a service disconnect.

A - pole-bracket

B - banding

C - J-box

D - pole-bracket mount nut (4 each)

E - pole-bracket mount screw (4 each)

F - conduit plug

H - strobe-bracket

I - 6-32 X ½ screws (4 each)

J - strobe light

K - M4 X 8 screws (3 each) (Low voltage)

K - 10-24 X ¾ screws (2 each) (High voltage)

18 Remote Mount Beacon/Strobe Installation Instructions

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

Keine Kommentare

Code-blue CB 9-S SIGNATURE SHORT ENCLOSURE Bedienungsanleitung Seite 28